These limits are designed to provide reasonable protection against harmful interference in a residential installation. Such modifications could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Operation is subject to the following two conditions: this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC and Industry Canada license-exempt RSS standard(s). RND button: Press once to activate the random feature.ĮNTER button: Press to confirm indicated settings. Press once to return to Auto mode when in Manual mode or Random mode. RESET button: Press and hold for three seconds to reset the system.ĪUTO button: Press once to activate the timer after programming is complete. Press and hold both + and – to switch Timer into manual mode. “+” and “-” buttons: Press to scroll through Press twice to set or change programming. SETUP button: Press once to set the calendar/clock. NOTE: Push the SETUP button to save and skip programming mode after saving.Program OFF: Repeat b steps to set off day and time.Continue to use the +/- and ENTER buttons to set the hour and minute ON times. NOTE: Press ENTER again to enter time setting from the screen with PRG and days flashing.Select Time: Use the +/- buttons to scroll to the TIME option and press ENTER. Select Day: Use +/- buttons to select the days and press Enter to confirm. Program ON: Use +/- buttons to select the program number and on and push ENTER button to set.Press the SETUP button twice and “P1 ON” will display.NOTE: Refer to Detailed Instructions for extra features for DST (Daylight Savings Time), Time Zone, SUNUP and SUNSET. Continue to press the ENTER button to skip DST, Zone, Sunup, and Sunset settings.NOTE: Ensure that you set AM/PM when setting the hours. Continue to use the +/- buttons to set the month, day, hour, and minute. Use +/- buttons to select the current year and press ENTER.Press the SETUP button and CAL will begin to flash.Shut off power at the fuse box or circuit breaker before performing any wiring or installation NOTE: See the installation section for wiring instructions. Contactor turns on fan motor Square D contactor at Grainger I buy these contactors at local HVAC supply for $15 add a comment if you need help wiring this device.DEFIANT DAYLIGHT ADJUSTING INDOOR DIGITAL TIMER User Manual Timer turns on 120 volt, 7 watt contactor coil. B) work around: Hook timer up to a contactor/relay. The CTD flashes during countdown.Ī) GE 15069 image at Amazon 15069 manual Manual shows GE 15069 countdown timer is rated up to 1/2 horsepower Whole house fan is likely 3/4 horsepower > check nameplate on fan motor. You can set the time interval from 99hrs out.Ĭlick OK to confirm. There is a countdown setting too - not sure why anyone would use it. Turns lights on and off within 30 min of your time - for a "random" appearance. again, and it will restore the old setting. Press Menu and select the on/off setting you want to delete. Press OK to select 1 On, the week day flashes. There are 16 different times you can set. When the Day flashes, press + or - to set the day.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |